Six tub grinders. Five BaleBuster bale processors. Seed drills and the Rock-EZE rock picker. Browse the line below, or answer three questions and we will point you at the right machine.
Straight to the specs. Or answer three quick questions below and we will point you at the right one.
If you want the material chopped fine (2-4 cm or finer) for feeding, grain, or biogas, you need a tub grinder with a BigBite hammer mill. If you just want to shred and spread whole bales, you need a bale processor.
Most customers get the best return when they can batch all their grinding into about one day a week. That leaves six days where no one has to worry about grinding. Size the machine for one day of grinding at the weekly volume you need. Not tonnes per hour chasing its tail. Tonnages below are for straw and hay. Grain is roughly double (weight per cubic meter is higher).
Pick the one that best describes your setup. This may override the model we’d otherwise pick based on volume alone.
The BB-2800 is our only machine with hydraulic squeeze bars that self-load any bale. Round or square, large or small. The others can handle square bales, but you’ll need a telehandler or loader to get them in. The BB-2100 is round bales only.
This will pick between the different BaleBuster configurations.
The nutrition numbers on a HayBuster are proven, but what makes our customers passionate is what happens in the barn. Feeding time gets cut in half. The ration comes out homogeneous so cattle can’t sort. They just eat. Dust comes off the material when it’s ground, so feed that would have been thrown out gets back into the ration. Intake goes up, especially on dry cows. Waste goes down. Feed costs go down.
That’s why sizing for one day of grinding per week matters. Six days of your operator’s time back, and a better diet in the bunk every day of the week.
Throughput figures in normal conditions at a 3 to 4 cm chop length and less than 20% humidity.
| Model | Power | Throughput | Hammers | Best For |
|---|---|---|---|---|
| H-835 | From 75 HP | 3 to 5 t/h | 48 reversible | Compact |
| H-1000 | Tell us your tractor | 8 to 10 t/h | 64 | The worldwide standard |
| H-1030 | 150 to 315 HP | 15 to 18 t/h | 64 HD | The workhorse |
| H-1135 | 200 to 315 HP | 20 to 25 t/h | 88 forged | Largest HD PTO grinder |
| H-1135E | 300 HP Electric | 20 to 25 t/h | 88 forged | Feedlots & biogas · no tractor |
| H-1155 | 475, 540 or 630 HP | Up to 60 t/h | Commercial | Self-powered · fifth-wheel |
Full per-model specs live on each model page. Not sure which screen? Read the screen selection guide. BaleBuster, seed drill, and Rock-EZE specs available on request.